With the help of the forum members I edited the SINUMERIK 804D POSTPROSESSOR for the machine with an 802S / C controller. (Thanks!)
As a result, the use of CYCLE has been adjusted according to the connection of the 802S / C controller. During the execution of the program, the machine performs twice the drilling of the first drill (which is supposed to be done only once).
What changes should be made to POSTORISESSOR to prevent the machine from performing this dual operation?
N23 S5000 M3
N24 G54
N25 G0 X3.2 Y-3.6249
N26 G0 Z0.2
N27 M8
N28 G17
N29 F13.33
N30 R101=0 R102=0.2 R103=-0.2 R104=-1.7 R110=-0.55 R111=0 R105=0.25 R109=0.25 R108=13.3333 R127=0 R107=13.3333
N31 LCYC83
N32 X3.2 Y-3.6249
N33 LCYC83
N34 X4
N35 LCYC83
N36 X4.8
N37 LCYC83
N38 G0 Z0.2
N17 M9
N18 T5 D5
N19 M6
N20 S5000 M3
N21 G54
N22 G0 X3.2 Y-3.6249
N23 G0 Z0.2
N24 M8
N25 G17
N26 F13.33
N27 MCALL CYCLE83(0, -0.2, 0.2, -1.7, , -0.55, , 0, , , 1, 0, , 0.35, 0, 0.25, 0)
N28 X3.2 Y-3.6249
N29 X4
N30 X4.8
N31 MCALL
N32 G0 Z0.2
N34 G0 SUPA Z0 D0
N35 M30
