Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
As with most professional surface machining software, have a 'constant cusp height' input for parallel machining (and any other strategies that could support it).
Completely agree. In HSMWorks it even shows the cusp height in "scallop", this is missing from HSM and Fusion.
I think its pretty hard to do a cusp height calculation for parallel as it depends on the slope angle, but for a scallop toolpath it would be perfectly possible.
