Poorly calculated toolpaths

[Anonymous]

Rest machining  from tool .

https://youtu.be/mLT-862oysY

[Laurens-3DTechDraw]

Without the actual path it's going to be very hard to find out where it goes wrong.

If you cannot share that publicly I would advise sending feedback to the developers.

[Anonymous]

Model:

http://download.hellshare.cz/2565-39-zip/42667874/

[Rob_Lockwood]

not very often I get to say this, but dang. Has that 'from tool' option been there all along? Don't think i've ever noticed that one.

[Steinwerks]

---

@Rob_Lockwood wrote:

not very often I get to say this, but dang. Has that 'from tool' option been there all along? Don't think i've ever noticed that one.

---

Seems a much better option to choose "From Previous Operations" so it actually looks at the remaining material. Might not be causing the issue, but dollars to donuts it's a contributing factor.

[jeff.walters]

i was going to take a look at your file but im getting a message that its not available in the US. 

[Laurens-3DTechDraw]

@jeff.walters

Same problem here.

[Rob_Lockwood]

right, I can't think of a place i'd actually prefer to use this, but it likely has a benefit of improved computation time in some instances.

[al.whatmough]

@Rob_Lockwood  yes, it cacluates faster.