Sweep or Loft to cut

[mbradleyDDG6T]

Greetings,

I am trying to cut a radius profile along a corner to create a smooth radius.  I am trying to use sweep or loft to make the cut to no affect.  I've attached the F3.

Thanks,

Mark

[g-andresen · Accepted solution]

Hi,

maybe something like this?

or this?

günther

[mbradleyDDG6T]

Thanks for the help!!!

[jhackney1972]

It is normal and good Forum etiquette, to "Accept Solution", on the Forum post "you say" helped you solve your issue.  But instead, you marked your post, which helps no one, as the solution.  Take a look at this article and find out how you can change your marking.  If you cannot figure it out, come back to me and I will do it for you.

[mbradleyDDG6T]

In the 2nd option, smooth fillet, I can make the same selections but do not get the OK button to light up to create the new body.

[mbradleyDDG6T]

Greetings John,
In the 2nd option, smooth fillet, I can make the same selections but do not get the OK button to light up to create the new body.

[jhackney1972]

@g-andresen, I think @mbradleyDDG6T meant to address his previous post to your attention since I was not involved in your solution.

[g-andresen]

Hi,

did you uncheck "extend option" ?

günther

[mbradleyDDG6T]

Yes, I've tried that as well.

[g-andresen]

Hi,

---

@mbradleyDDG6T wrote:
In the 2nd option, smooth fillet, I can make the same selections but do not get the OK button to light up to create the new body.

---

Please share that file.

File > export > save as f3d on local drive  > attach it to the post

günther