Spline along different construction planes.

[charlescooke58]

Its me again. I want to construct a Spline along different const. planes so I can loft out a multi chine boat. I have included a screen shot in multi view ports. The spline starts at the front of the boat down to to the middle section and up to the rear. It also starts at a point at the front bulging out towards the middle and then decreasing to the rear again. How do I draw this?

[jeff_strater · Accepted solution]

I think you need to enable 3D Sketch:

This setting will allow you to snap to the ends of existing section curves, or any points in 3D.  You can also use it to place points at arbitrary locations in 3D.

[charlescooke58]

Thanks for that it worked. Oh what a feeling.