solid with sloped faces

[falchi.matteo]

Hi everyone!
I really need your help..

could you please tell me the necessary steps to make a solid with 4 inclined faces? like the attached photos..

Thanks in advance!

[WHolzwarth]

One possible way is splitting with workplanes.

[falchi.matteo]

Hi, thank you for your solution!

could you describe me the steps to do it? sorry but it's been a while since I use Fusion360 as a self-titer .. Thanks again!

[WHolzwarth]

Steps can be followed by moving through the timeline at the bottom of the screen.

- Create an initial box

- Create 3 workpoints, preferably at any edge
- New workplane through these points

- Split the body with this plane

- Switch the new smaller body invisible

😏 And so on, and on ...

[davebYYPCU]

There are many ways to do it, 

Make a surface top roof, and replace face of the extrude to it.

Might help.....

[falchi.matteo]

Hi, thanks for the solution!
I have a question for you .. I have come up to the union of the surfaces, I create a unic body from these, but I cannot extrude, it does not detect the supercifi as a single body .. what should I do?

Thank you!

[davebYYPCU]

Extrude Sketch 1, down a bit.

Use Modify > Replace Face, select top face (source) of your extruded body, and the target is the Surface body, select it from the Browser List, should look like this, 

Press Ok.  Add fillets...

[falchi.matteo]

I did it!
Thank you!

but I have another question .. how can I perfectly bring the construction line of sketch 1 to the new plane?

Thanks again!

[davebYYPCU]

I used the Sketch 1 construction line for the Plane on Angle, for sketch 2

Create Sketch 2, then Project > Project that line into Sketch 2.  Draw the normal line above it and make the end points vertical to each other for accuracy.

Might help...

[g-andresen]

Hi,

PROJECT (P)

günther