Fusion
Whenever I'm using 3D adaptive to clear a pocket to depth with the full flute length, I can not get rid of these small moves on a vertical wall at the of the path
You might find making the tolerance smaller will help, default is 0.1mm, 0.01mm usually helps but calculation time will be longer. Also are you using a boundary curve to contain the pocket? I have seen that cause problems if you have it set to tool inside, you might want to experiment with the additional offset. Is there any draft, setting the fine stepdown to the same as the stepdown might help as well.
Are you able to share the design? If you can share it and need more help, export as an f3d and attach.
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
