Sketching broken continued ...

[hoegge]

After having not used Fusion much for a few months, using the sketch environment today showed some bugs. 

After drawing a sketch with more than e.g. 30-50 lines, the snap to features when adding a line stops working. It simply stops recognizing the points already drawn. PLEASE start focusing more on test and performance now. It is way overdue

[TheCADWhisperer]

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

[jeff_strater · Accepted solution]

Yes, please share the design here.  Snapping works fine in every case that I have seen.  Just relative to one of your other posts:  sketching-broken-continued-part-2 , if your sketch is not on the sketch plane, then snapping will not work as you expect - you can snap to 3D geometry only if 3D sketching is enabled.  Again, a model and a screencast would help.

[hoegge]

Yes, as Hughes tooling suggested, that is probably the problem - out of plane points. Really wonder how that happened, since I only turned 3D sketch on for two lines and then turned it off again - but either 1) can solving constraints pop in-plane things out of the plane? or 2) I did NOT turn it off in time. In which case it was my brain and not sketching, that is broken. Embarrassing 😄 Anyhow - the out of plain points was the problem. They were only around 2 cm offset on a drawing with lengths around 20 meters.

I've added sketch and screen cast in the original post.