Sketch object input - only works for one input.

[ste1nar]

When creating a sketch object with two measurement inputs, very often only one input actually works.

Here's a gif.

In this gif it's always the first rectangle input that works, and always the angle of the line. But that is not always the case, when I was doing this before recording, the rectangle had about 50% chance for which input would work and which wouldn't.

After a fresh start there's a decent chance that both inputs will work, but soon after, the above issue appears.

[HughesTooling · Accepted solution]

I guess you're using Win 7 that's no longer supported? The workaround is go to the shortcut you use to start Fusion right click, select properties then on the comparability tab set the compatibility mode to Win 7.

Mark

[g-andresen]

Hi,

another way.

Split the process:

1. create element (line, rectangle, ...) > ok

2. dimension it (D) > ok

günther

[ste1nar]

Wow, did not expect that to work. Had not even crossed my mind to try to set the compatibility mode.

Thank you and others for suggestions.