I noticed the origin of a sketch that's created while creating a mesh section is not selectable. File's attached.
Mark
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
A Mesh Section is not really a true sketch until you edit it and use the Fit Curves to Mesh Section. This is the way it was explained to me. This command will add the sketch origin. You cannot use the Mesh Section for anything unless you use this command on it anyway.
John Hackney, Retired
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
The sketch that contains the mesh section is a sketch and should work like any other, you can create any geometry in it but without the origin you can't fully constrain it. Of course you can project in the component origin.
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Here's a screencast, shows after creating a curve with fit to mesh sections you can't constraint it to the origin. Pretty sure this used to work.
Mark
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Fusion
