simulation not working after update to only cloud solving

[eric.meijer487FF]

When i try to solve a simulation I get this error:

Error: The model could not be translated for simulation because it is for a version of Fusion or has schema changes ahead of what the translator is capable of handling.

This started since the simulation is only possible in the cloud

None of my simulations are working

[johnAMKDR]

The silence says a lot doesn't it.

I dug up some heat transfer simulations from a couple of years ago; they ran, slowly, but gave unbelievable results like 9000 degress on a 1 meter square sheet of steel with 50 watts input. When I ran it before the spot of application got to about 80 C. I did have to touch the parameters to get it to start the solve so I'm not sure they were truly the old simulation setups.

I tweaked the design a bit to better define where the heat is applied. The precheck was fine but I got a singularity in the stiffness matrix. "If using shell elements, either set the K6ROT model parameter to ....". I bet that's not in the help file.

I ran a static linear (free) simulation, and although it wasn't absurd, I don't know whether to trust it.