Sheet Metal Mitring Flanges in Opposing Directions

[kyle.brett1]

Hey all, 

So I'm really new to Autocad, so I'm sure the answer is blindingly obvious. However I need some help. I am trying to mitre these two intersecting edges neatly. Hence why I put them in the flange (to try use the mitre tool). I have been spent hours trying to come up with an answer but have had no luck. 

Any and all help is much appreciated!

Cheers

[g-andresen]

Hi,

Please share the file.

File > export > save as f3d on local drive  > attach it to the next post

günther

[salival]

Hey,
If this was me I would leave those corners how they are and use "Split Face" to do the mitering for you then unfold (if applicable) and extrude cut the pieces left from "Split Face"

[kyle.brett1]

Hey Friend, 

I am sorry for such a late reply. I hope you're still willing to help. 

Cheers

[kyle.brett1]

Hey,

Thankyou for your suggestion, however I am struggling to make this method work. As the project wont let me lay into a flat pattern; and these are two intersecting flanges on the same body. If I'm not understanding what you're trying to say correctly I hope you can find the time to give me a little bit more help.

Cheers