Fusion 360 crashed today when I resized an offset with a fillet so that the fillet size became 0. This has happened to me several times before.
I tried to recreate the problem by doing the following:
- Create a new sketch
- Create a rectangle from origo, and specify dimensions so it becomes completely constrained
- Create a fillet in one corner
- Create an offset of the rectangle with fillet corner with "chain selection" checked
- Delete the dimension defining the offset
- Resize the offset by dragging it so that it becomes small enough for the fillet to be of 0 size
But of course it didn't crash this timeā¦
Fusion 360 2.0.13881
MacOS 12.5
iMac Retina 5k late 2015
Also, I was going to make a Screencast showing this, but trying to launch Screencast from Launchpad doesn't give anything, and launching from CLI just gives several lines with error
libpng warning: iCCP: known incorrect sRGB profile
Fusion
