"Body would self intersect" when using Sheet metal bending tool

[Jansenpbarralet]

I know there are a few posts on this already answered by @jhackney1972 but I don't think any of the answers apply to my problem. I have added the bend allowances so that should not be the cause of my issues (at least I hope). As far as I can make out nothing should be intersecting with itself so I don't know where to start to try and find a solution.

Any help would be much appreciated!

[Jansenpbarralet · Accepted solution]

I have found the issue, it was a rounding error on my part for calculating the bend radius...