Project Toolpath Not Following 3D Surface

[buildsbygideon]

I'm attempting to project 2D sketch geometry onto a 3D surface to engrave. However I'm not getting the outcomes I'm looking for.

I'm using the Project toolpath, selecting the geometry, and it would produce what looks like the correct path. However, when simulating it, I noticed that as it goes down a curve or steep area, it will hop over and have an almost delayed effect before it starts curving. 

I tried getting around this by projecting the geometry directly on the surface in the modeling section, but I get a weird result of only projecting a portion of the line segment.

[TheCADWhisperer]

You should probably post your question >>over here<<.