Probe Collides with stock when WCS Probing.

[wtluebbers]

I am trying to setup my first probing cycle and was wondering if someone knew why my probe says it is colliding with stock when I am trying to probe. Attached are some photos that will hopefully help.

It never seems to actually collide with the stock. 

It only gives me a collision error on the Y- and X+ directions.

I have not tried to set up my own tool yet. I am using a sample probe.

Any help would be appreciated.

Probe SettingsProbe SettingsShowing no error during any prior movesThe beginning of the error right as the y travel begins.The furthest that the tool travels towards the stock

[seth.madore · Accepted solution]

Yes, this is just a graphical issue, we have tickets to improve this rendering, but I'm not aware of the priority that this has.

[wtluebbers]

Awesome, thanks for the answer. That works for me!

[mattdlr89]

@seth.madoreIs this still an issue? First time trying probing today and every time it "probes" there's a collision warning a little disconcerting but probably fine?

[seth.madore]

@mattdlr89 Yes, still an issue

-EDIT-

I "thought" it was resolved, I'm asking the folks at ADSK if that's not the case.