Fusion
Why are you using Pattern on a Path, why not use Circular Pattern? Please attach you model.
John Hackney, Retired
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Depends, please attach your model and the forum users can try and tell you the reasons it will or will not.
John Hackney, Retired
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
Now if you want a partial pattern around the path or special spacing, that is a different story. If you are doing a complete circle with equal spacing, the circular pattern is your tool. If you do measure the length of the path and enter it in the Pattern on Path, it normally will work OK also.
John Hackney, Retired
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
This is one of those models that requires you to use "Faces" for the Type of entity you are going to pattern, in this case Pattern on a Path. The reason, I believe, is the fact that the holes are not tied together but span a distance. I also believe the partial intersection of the hole, on the concave side, with the concave edge requires the Type to be Faces. Model is attached.
John Hackney, Retired
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
