Fusion 360 crashing upon startup

frederikhoffostergaard
Observer

Fusion 360 crashing upon startup

frederikhoffostergaard
Observer
Observer

Spent hours so far, nothing works! Everytime I start fusion and log in, it crashes. I get "A software problem has caused fusion to close [...]" Report details says: 'access violation - code c0000005' module name: dspluginAFCOM.dll

 

i have tried everything on this list: https://knowledge.autodesk.com/support/fusion-360/troubleshooting/caas/sfdcarticles/sfdcarticles/Aft... 

 

Nothing works. My license recently expired, however, i followed the guide to renew but it still does not work. Is it because I have used the software for 3 years on personal license ?? Does it die completely after that? 

I really hope someone can help, as i have quite an important project to finish which i have spent A LOT of time on ..

0 Likes
Reply
Accepted solutions (1)
257 Views
2 Replies
Replies (2)

RajkumarIlanchelian
Autodesk
Autodesk
Accepted solution
1 Like

THANK YOU ! took 10 seconds.... should have written here hours ago!. Thank you so much 🙂 

1 Like