Fusion 360 crashes

[andrewkunitsa]

After the last update of Fusion 360, I stopped opening a large file with many components. At startup, the program just crashes. In the task manager, the RAM and the processor are not loaded 100 percent. Maybe this is some kind of coincidence? Before that, the file opened normally.
Computer specifications: Ryzen 2600x,  gtx 1060, 16 GB of RAM.

[ClintBrown3D]

Not sure if this will help you, but there was a recent Windows update that seemed to roll back some AMD graphics drivers.

Run the Graphics diagnostic tool in Fusion (before you open any files) and then click on the "Check for GPU driver update". This will take you to the AMD driver website, from here you should be able to find the correct driver for your graphics card. Install the latest one and see if this sorts out the problem.

[andrewkunitsa]

Thanks for your reply.

Unfortunately it didn't help.

The most interesting thing is that the same file runs, albeit with difficulty, on a MacBook Pro 2011 with 4 GB of RAM.