Extrude to the circle face.

[DanylovDmytro]

Hello.
I have a Circle on a scketch and a sphere.
So, if the sphere has size A, I need to extrude the Circle "to the objet", so the end of the cylinder would be rouded.
But if the size of the sphere is B, i need to extrude  this circle again "to the object", but to have the ending flat like if i use "profile plane".
Is it possible to make in parameters and configurations?

[g-andresen]

Hi,

Please share the file and show a picture of what you want to achieve.

File > export > save as f3d on local drive  > attach to post

günther

[davebYYPCU]

Can be done without configurations.

Set Circle to any size.

Extrude to the plane, 

Combine > Cut the sphere from the cylinder.

Might help...

[DanylovDmytro]

As you can see from the picture. If the size of the wall is A, i need extrude to be from Object. But if it's B, it should be also from Object, but with the flat ending and 0.5mm from the outer surface of the ball.

[TheCADWhisperer]

@DanylovDmytro 

If this were my design - I would not be using Move to locate the feature. 

What is your Design Intent - what are you attempting to model?

Do you have a picture of something similar that already exists in the real world?

[g-andresen]

Hi,

An extrusion from the object ends with the profile of the object, while an extrusion from the profile (even with offset) always has a flat surface ( perpendicular to the extrusion direction).

günther