Solved: Drill Hole Operation - Unable to select holes. F3d attached

Anonymous · ‎11-15-2020

I'm working on a custom cribbage board for a client and I'm unable to set up a drill operation for the peg holes.
I imported a dxf file that had my sketch with 1/8" holes and extruded everything to the correct depths.

Any help is greatly appreciated.

HughesTooling · ‎11-16-2020

The DXF you imported is using splines not circles so the holes are not recognised. Does the program you made the DXF with allow export of circles.

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

Anonymous · ‎11-16-2020

I went back to the dxf that was imported and had to hand-select each circle face one by one rather than grabbing the outer arc rings of the circle. Painfully slow - but did the trick! Thanks for the help!

Anonymous · ‎11-16-2020

@HughesTooling Well - I thought I had found a solution but it was only the new holes I drew manually in the sketch via fusion.
I use adobe illustrator to make my base sketch and import as dxf. Some reason the circles are turning into arcs.

I'll have to manually draw circles for now.... 😞

I did get the render to look correct and I'm excited to get this prototype made!