Community
Fusion Support
Report issues, bugs, and or unexpected behaviors you’re seeing. Share Fusion (formerly Fusion 360) issues here and get support from the community as well as the Fusion team.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Can I get rid of the extra input box that follows your cursor?

0 REPLIES 0
Reply
Message 1 of 1
steve3957T
48 Views, 0 Replies

Can I get rid of the extra input box that follows your cursor?

I'm not sure what it's called, but the little input box that pops up during commands like extrude, pattern, ect.  During extrude, as soon as a profile is selected, this box pops up wherever I clicked, then follows any clicks made after that.  It is a constant annoyance, but I can't figure out how to turn it off.  I can dock it somewhere, but it only stays until the end of the command and then follows me around again the next time.

0 REPLIES 0

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums