Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Beer Flight Board

svweber
Observer

Beer Flight Board

svweber
Observer
Observer

I'm looking to print beer flight boards for 4 5oz tulip style glasses. I have the design done, just need to figure out how to make the holes for the glasses. I want them to match the outside shape of the glasses so they fit nicely. The board will be .75" thick. So the holes need to be bigger on the top layer, and smaller on the bottom, but rounded to match the glass shape. How do I accomplish this? Thanks!

1000005466.jpg

0 Likes
Reply
293 Views
6 Replies
Replies (6)

Warmingup1953
Advisor
Advisor

Revolve. Are you familiar with importing an image as a Canvas and then calibrating that?

0 Likes

g-andresen
Consultant
Consultant

Hi,

Do you want to insert the glasses from the front or from the top?

 

Günther

0 Likes

TheCADWhisperer
Consultant
Consultant

@svweber wrote:

I have the design done..

 @svweber 

Can you File>Export your *.f3d file to your local drive and then Attach it here to a Reply?

0 Likes

svweber
Observer
Observer

I have the measurements of the glass and so the measurements for the hole. Not sure if that is the same thing. Forgive my lack of knowledge here, just started designing a few weeks ago. 

0 Likes

svweber
Observer
Observer

I have legs on the bottom so the board sits up, so the glass will be suspended. We insert the glass from the top. 

0 Likes

g-andresen
Consultant
Consultant

Hi,

create your profile in sketch 2 and try this

günther

0 Likes