Update and crash !!!

[RitchieFromParis]

Crash aft the last update, I will lost again this day !!!! but all is ok with Fusion !!!!!!!

[jesper8W75R]

Same here, crashing over and over on the restart after the update.

So far, 5 times, still not able to get it running.

Great work Autodesk, you can be trusted to always deliver a piece of junk to raise our bloodpressures.

[RitchieFromParis]

Hi my friend ! 

Really ? happy to be not alone !! 🙂 😞 

I am tired...

[jesper8W75R]

Yeah, it's sad.
I am now on restart (and crash) number 12 or so.
Restarted my Mac, used the Fusion service utility to reset Fusion, Repair Fusion, Reinstall Fusion.
Nothing works.

Now I have to call two customers and tell them that their boards will be delayed because I am stupid and use a crappy program made by incompetent developers.

And who's going to repay me for several hours of lost income?
The same stupid guy.
Me.


Sigh!

[RitchieFromParis]

It's incredible !!!!!!!!!

Same for me ! I will report the job today.

In addition the price of the license has increased! but not Fusion.

Have a good luck...

[jesper8W75R]

After totally uninstalling and erasing Fusion and downloading a new Insider Installer, I finally got it up and running.
But still a lost day.

[RitchieFromParis]

Really good news for you ! 

Me too after 7 hours of works...and same for me one lost day... 

Have a good day

[silvio3105]

You have to have really big balls to use Fusion for anything else than hobby projects 😄

[jesper8W75R]

I KNEW I was too optimistic.
After running it for about 10 minutes:


What an utter piece of ****!

[RitchieFromParis]

Oh my god ! 😱

I never use Fusion for big and professionals projects ! just for small projects, like Led or potentiometer PCB.

it's not serious I remember use Eagle for a Satellite transponder, with Fusion NEVER !!!!!!!!

Otherwise the satellite would have already fallen to earth...😩

[jorge_garcia]

Hi @RitchieFromParis , Hi @jesper8W75R ,

Sorry to reach out to you in these circumstances. Is this still happening?

Was it crashing just when you were trying to start the program, did you not get to do anything that could cause the crash?

Let me know if there's anything else I can do for you.

Best Regards,

[jesper8W75R]

It was happening after the update, it's not happening now.

But, it crashed repeatedly after the update, I tried various approaches, reset, repair, reboot my mac, but after about 12 crashes, I completely uninstalled Fusion, reinstalled it and it finally started.

But then, I got other errors, as usual.
So, it's still a piece of s*.

[RitchieFromParis]

Hi Jorge,

Same ! It was happening after the update, after a clean install all seems to be ok, but crash sometime without error log.