UNEXPECTED FILLET BEHAVIOR

[josh.sapp]

Fillet is not coming out smooth. I don't remember it overlapping itself before. Could someone else take a look for me.

[Robert_J_Scott]

I can only presume its a graphics issue as I produced the groove and the rads on the initial sketch for the revolve and it's exactly the same. 

I had the same issue on a part a few weeks ago, I couldn't do anything with that either but the part came out fine. Just double check your code and write this down to another "quirk" with fusion.

[Steven_Gao]

Yes, this looks like a graphics display issue for small fillet. I tried to cut one half and see the "section" is fine. Will report it to development team for further investigation. 

[Steven_Gao · Accepted solution]

It is a known graphics display issue(FUS-157292) for development team and will consider it for future enhancement. 

[g-andresen]

Hi,

might help

günther