Under Manufacturing tab selecting Create from Template the template is blank

[mike_miller515]

Ever since last update whenever i am in the manufacturing tab and want to perform machining operations, by using my templates, Fusion doesn't display the templates until i select another machining function and fully create a path with it.

Once i've done this in any drawing one time it will display them from then on. 

If i open a new drawing and try to manufacture it, it does the same thing. It's very annoying.

[seth.madore]

You mean this flow?

What I see:

 

 

[mike_miller515]

No what i mean is when i actually select the template it doesn't show up in the tree. I must open another operation such as drilling etc. and generate a path with it. Then the templates show up in the tree.

[mike_miller515]

Here is a photo of me selecting the template, then the next photo is the template not being put in the tree.

I won't get to use the templates until i create another operation first.

I see nothing:

after i create a drill operation

[seth.madore]

ohhhh....

[seth.madore · Accepted solution]

So, I went through your steps, and this is what I "think" is happening:

1) It creates the toolpath, but the Setup is collapsed. 

2) Clicking on this "caret" will open up the folder of "Setup":

 Result:

 

[mike_miller515]

yep that fixed it, my first assumption was that the update messed something up. I should have looked at that first, thank you!