The icon in the operation bar became large

[2558118594]

When I was using fusion360, my computer was shut down due to power failure. When I started fusion360 again, I was prompted to jump to the website to log in again, which did not happen during the previous restart. The most important problem is that after entering the software interface, the icon in the operation bar and timeline are much bigger than before, which seems to be the problem of resolution setting. However, after I adjusted the DPI setting, there is still no effect.

How can I solve this problem？

[sutherland-]

Hi @2558118594 

Is your Fusion 360 and computer drivers (such as graphics driver, OS, etc.) up to date?