sweep surface with circle as path

[josef.schadlbauer]

hi community,

lately i've been playing with the sweep command and i've been trying to get a hyperboloid as surface. so i've created circles and a line. 

now i want to sweep the line along the outer circle to get a hyperboloid. the problem is, that the surface is not created for the full circle (an error occures). when i try the same for only parts of the circle it works. is there some possibility to create the whole surface?
thanks for your help.
josef

[dsouzasujay · Accepted solution]

Hi @josef.schadlbauer 

Can you check this video from BuMath Explorations can help create a hyperboloid in Fusion?

3D Design: Created a Hyperboloid as a Ruled Surface in Fusion 360

[TheCADWhisperer]

@josef.schadlbauer 

Are you OK with Pattern and Stitch?

[g-andresen · Accepted solution]

Hi,

it works this way too

günther

[josef.schadlbauer]

amazing, thx (:

[josef.schadlbauer]

i did this aswell, but it seems a little bit comlicated...