I was under the impression that things like this did not happen. So I'm making a 3D logo, and I'm making little models of things I want to include. I'm modeling this speaker, and initially I model it larger. Finish it, redimension the sketch, then I see it's not working well. Many things went yellow and red. So I changed it back. The sketch lines were not attached, causing an extrude to fail. I reattached them...but it still was not a profile. I checked the points by zooming in, restarted fusion, reprojected the lines...I can't get it to make a profile, and it definitely should be one. What is going on?
