"Error: loop does not contain given vertex" when adding a Fillet

[dezdan]

While trying to add a simple fillet to a shapes corner, I receive the error "Error: loop does not contain given vertex". There is very little info on this error. The matching corner on the shape I was able to add a fillet without issue. Has anyone else encountered this error and found the cause?

[jeff_strater]

please share the model here, impossible to tell more without seeing the model, and knowing what edge(s) you are trying to fillet, and to what radius.  Thanks

[dezdan]

Thank you. What is the best file type to share the design (personal use version)?

[jeff_strater]

Thanks.  Export as "Fusion Archive (F3D)", and attach the F3D file here.

[dezdan]

Thank you. File attached. It is the lower front right corner; settings in the screen shot. This is my second design ever, so still learning and trying to figure the error out.

[jhackney1972 · Accepted solution]

If you edit the first sketch, in your timeline, removing the two Coincident sketch constraints and then replacing them in a certain order, will allow your to edit the edge in question.  The Screencast will show the process.  Repaired model is attached.

@jeff_strater I really think this is a flaw in the application and should be looked into further but of course, that is my opinion. 

[dezdan]

Thank you John! I appreciate the break down and steps you outlined on how to fix the problem!