Post Processor for Panther

[Anonymous]

Hi team,

What's the post processor that is required for a Panther CNC Plasma 1325?

Thanks!

[will_1]

Hi @Anonymous ,

Do you know what controller it uses? We may have a post processor for the controller type.

Thanks,

Will

[Anonymous]

Thank you for your reply the controller name say's- CNC Cutting Controller
CC-M3

[will_1]

Hi @Anonymous ,

Do you have sample nc code? If you can post or send it we might be able to suggest something that is close.

I have sent you a direct message with some additional information so be sure to check that.

Thanks,

Will

[Anonymous]

Thanks for your reply Will, cutting a long story short, I am using fusion
360 on my Langmuir Pro which I have done for the last 3 Months I can draw,
post process & G Code.
I have a neighbour that has the Panther Machine and has had it for 2 Years
and has not cut 1 part on it, I tried his software which is Fast Cam and I
could not complete a drawing or go any further, we are both in our 60's and
Dumb Arses on computers, so I was going to draw something on my computer at
home on fusion 360 to use in his machine that's why I asked for the Post
Process for his machine, if I could get it working off my Fusion program I
was going to get him to install fusion 360 on his computer and get rid of
Fast cam, it is to complicated to work out, so I have no idea what to do
now because I am unable to supply you a NC.
He approached the manufacturer of his machine and all they said was use the
software provided-(No Service/help at all)

Thanks
Tony Huysmans