Pocket issue - different sizes IRL to fusion drawing

[rebecca.shillito]

Evening

I have been making some quick jigs up in Fusion, making use of the Nifty Slicer to expedite the process.

Please see the attached file.

The issue I am facing is that the milled pockets are about .5mm smaller on each edge than the drawing.

.

All other dimensions are as they should be.

I'm thinking this is the pocketing strategy that I am using but can't work it out.

Any help would be greatly appreciated.

Thank you all in advance!

[HughesTooling · Accepted solution]

Could be defection depending on how ridgid you setup is. Try enabling finish cuts with a 0.1mm for the last cut.

[rebecca.shillito]

Brilliant, thank you that worked a treat!