Plane Selection

[russellmcaliece]

When I select sketch mode and the plane I want to use, fusion does not automatically align to the selected plane. Why is this happening? It did not use to be like this.

[jhackney1972 · Accepted solution]

There are two reasons for this.  The most likely one is that you are sketching in 3D mode.  Start a sketch and check your Sketch Palette and see if you have 3D sketch checked.  If so, uncheck it then Finish Sketch and start a new one to see the result.

The other possible reason is you have turn off Auto Look At Sketch in your Preferences.