Phil McLean

[pmlGZWZG]

 cutting leg slot in sawhorse for Lincoln High School students. Plane inserted @70 degrees on edge of top platform but sketch of leg shape used to cut a rebate in the top platform doesn't cut @ 90 degrees (as shown) the other side of the cut is at 90 degrees - no taper selected - any solution (S) thanks community 

[davebYYPCU · Accepted solution]

Because the leg is splayed on two angles from the top plate, that angle would be more likely than 90 degrees, unless the leg is edited to make it so.

Might help....

[jhackney1972 · Accepted solution]

Please attach your model.  Open in Fusion 360, select the File menu, then Export, save to your hard drive then attach it to a reply post.

[pmlGZWZG]

thanks