Overconstrain bug I think
I think the problem is because you're dimensioning off an offset. If you try adding the dimension to the outer rectangle there's no problem. Also works if you use endpoints rather than selecting lines.
Here I've selected the end points.
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
By the way I don't think this is a bug because you're not allowed to use an offset to drive the source curves.
In the simple example below you are not allowed to dimension the inner offset rectangle to drive the source outer rectangle. If anything the workarond I gave you above is a bug that shouldn't work, @jeff_strater what do you think?
Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.
