No intersection between target(s) and split tool.

[Anonymous]

Hi everybody, I've searched through quite a few threads about this error but still can't figure it out. I'll preface this with I'm not all that familiar with Fusion360 (my brain wishes it worked like Illustrator) so this could be an easy fix but I've played around with it for a few hours now and I haven't figured it out. I've been following this Youtube video https://www.youtube.com/watch?v=o7ke2m4cUZA&t=9s  to 3D model eyewear frames which I make in my spare time , so I'm trying to learn how to utilize Fusion to eliminate a lot of time spent with handwork when I only model in 2D. So from what I can see I've done everything the same as the video but I run into the same error every time when I go to do the first split body step (6:50ish mark in the video). 

Any feedback would be much appreciated!

Thanks,

Travis

[jeff_strater · Accepted solution]

Assuming that you are referring to using the Bridge surface body to split the solid body here, you need a clean intersection between the target body and the tool body, which does not exist in the model you shared.  One way to get there is to extend the Bridge body so that it cleanly intersects the solid:

[Anonymous]

Thanks Jeff! Like I figured, it was a pretty simple fix. I appreciate you taking the time to show me!