Fusion crashes on startup

[Anonymous]

Hey there,

since yesterday I can not run Fusion 360 anymore. When Fusion is done loading everything it just closes the program without any message. This doesn't seem to occur when I deactivate my internet connection, so offline mode is still possible.

I am using Windows 10 with the latest updates, I am located in germany.

I've attached a video of the behaviour.

Any help appreciated.

[Anonymous · Accepted solution]

Ok seems like I fixed this by starting in offline mode and then going back online during the session

[Anonymous]

Mine started doing the same thing last week.  It has been fine up until then.  I ensured I had the updated graphics drivers, updated Windows 10, turned off my anti-virus, etc.  Even tried to download Fusion 360 on my brother's gaming laptop and it did the same thing.  I'm going to see if I can figure out how to start offline as you describe and hopefully it works...  I'm falling behind on my project for my after school STEM club.

[Anonymous]

Ok, it seems like starting offline and then going online works...  Any idea why?  Is there a way to get Autodesk to look at our accounts and figure out why this is happening??