Fusion CAM - Radius problem

[schmidt_be]

Hi there, any help is very much appreciated. I have a large CNC machine (Tekcel P2 Router). My jobs simulate in Fusion fine, however on the machine it cut's the radius incorrectly. Link to photo here:

https://woodcroftcollege-my.sharepoint.com/:i:/g/personal/schmidt_be_woodcroft_sa_edu_au/EYP-CYQSK_B...

Link to Tekcel Post Processor here:

https://woodcroftcollege-my.sharepoint.com/:u:/g/personal/schmidt_be_woodcroft_sa_edu_au/EZcjKTJwZi9...

My knowledge of where to look in the post processor is limited. Anyone that can help will be my savior!

Thanks,

Ben.

[g-andresen]

Hi Ben,

I think, a better place for this is the Manufacture Forum.

günther

[infoS89W5]

Hi, I've got the same problem. Tekcel K2, Did you get it sorted? If so, can you share 🙂

[TheCADWhisperer]

@infoS89W5 

https://forums.autodesk.com/t5/fusion-360-manufacture/bd-p/2070

[schmidt_be]

I did have some success. By unchecking the output circular check box in the post properties, it resolved the issue. I then edited my post to have output circular to default to unchecked. I assume not the ideal solution but seemed to work. Hope that helps.

Cheers,

Ben.