Fusion 360 has stopped workin asking for a new install. HELP!!!

[Anonymous]

I was working in Fusion 360 quite fine until the software just stopped. Any effort to open the sooftware give an error message asking for me to reinstall. How do I do this since when I look in control panel it is still there. It wont allow for a repair only a clean uninstall. 

[Dippeggs · Accepted solution]

This also just happened to me. I'm going reinstall and see if that fixes it.

Okay I reinstalled it and now it works. Kinda annoying it happened in the first place.

[Anonymous]

is there a link you can post for reinstall?

[ryan.bales]

Use this link to uninstall 

[Anonymous]

Thanks for the response. I did a new install and everything is fine now.