Crashing on Save as STL

[jodom4]

There's a known issue we're working on where Fusion crashes when saving as STL. Please go to comment #15 on this post for an explanation and possible work-around. https://forums.autodesk.com/t5/fusion-360-support/fusion-360-crashes-suddenly-when-attempting-to-use...

[Mike6158]

What did you change? It used to work without any problems, if you don't count taking a long time for even the simplest designs...

[Anonymous]

I had to do all kinds of stuff to fix it and it was fine for a few months but just loaded it back up again and it started with the problems again so now i have to dig to figure out what i did to fix it

[Anonymous]

dude....  black bars on the last update and now i have to uninstall software that i need to use your product...  this is piss-poor guys...  clean it up or give me my money back...