[BUG] Cursor stops durcing Creation of a Slot when getting to close to x = 0

[Centro93]

If I try to create any Kind of Slot in Sketch view, my Cursor suddenly stop when I get to close to 0 on the X-Axis, and only "reawakens" when I move away from 0 again. Zooming in or out seems to change the Distance to 0 at which this behaviour appears and even might remedy it.

[jeff_strater]

yes, this is intended behavior.  There is always a point at 0,0 in the sketch, and Fusion will snap to vertical and horizontal alignment with that point.  The snap range is set so that you do not have to be precise to align with this point.  And, yes, zooming in will change that snap tolerance.  You can suppress this by holding down CTRL (CMD on Mac), which will suppress all snapping/inferencing.