Areas selected for extrusion don't turn blue

[valentino_pi]

Good morning everyone.

Since the last upgrade, whenever I try to extrude a new body or modify an existing one, the selected areas of the sketch don't turn blue as they did before, even if I see that they are being counted. I can get an idea of what part are being extruded only if I then select an height for the extrusion.

Can someone help me solve this problem?

Thank you

[g-andresen]

Hi,

construction lines do not form profile contours.
Change them to solid lines
1. via sketch palette
2. select + shortcut x

günther

[valentino_pi]

thank you for your answer but that's not the case. there is a construction line close to the the line that closes the area.

As you can see, it does not turn blue not even with a simple closed square

[g-andresen · Accepted solution]

Hi,

1. change graphic driver selection > open GL ?

2. update graphic drivers

3. please share the file and mark the profile to extrude in a screenshot

File > export > save as f3d on local drive > attach to post

günther

[valentino_pi]

Thank you very much, changing the graphics driver to OPENGL solved the problem and selected areas are now turning blue again.

[valentino_pi]

Just a side note, the openGL solution worked on a pc with a graphics card in it, instead it freezes my notebook that only has intergrated graphics.

I've also tried DX9 but i had the same problem with it, not seeing the selected parts turbing blue