Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

What happened to chuck reference slider?

PatrickPowers-CGS
Advocate

What happened to chuck reference slider?

PatrickPowers-CGS
Advocate
Advocate

Turning ops. What happened to the slider for chuck reference?

 

chuck refernce screen shot.png

 

 

0 Likes
Reply
577 Views
8 Replies
Replies (8)

akash.kamoolkar
Autodesk
Autodesk

@PatrickPowers-CGS Not sure what's going on. Seems to be a problem specific to this file. I can see the chuck plane in every other file I open. I'll create a ticket for this.

 

Regards,

Akash Kamoolkar



Akash Kamoolkar
Software Development Manager
1 Like

PatrickPowers-CGS
Advocate
Advocate

I've had this happen with a few files. This is just the first time I've posted about it.

0 Likes

PatrickPowers-CGS
Advocate
Advocate

I'm also getting an invalid reference error when I reference the chuck front on turning op.

chuck refernce screen shot 2.png

 

0 Likes

akash.kamoolkar
Autodesk
Autodesk

@PatrickPowers-CGS We've determined that these issues only occur when stock mode in the setup is set to "from preceding setup". Can you confirm this?

 

Regards,

Akash Kamoolkar



Akash Kamoolkar
Software Development Manager
0 Likes

PatrickPowers-CGS
Advocate
Advocate

You may be right about the slider not being visible only when stock is from preceding setup.  But the issue that I'm having with the chuck front being an invalid reference in a tool path is happening every time.

 

 

0 Likes

akash.kamoolkar
Autodesk
Autodesk

@PatrickPowers-CGS can you attach your file here?

 

Thanks,

Akash Kamoolkar



Akash Kamoolkar
Software Development Manager
0 Likes

PatrickPowers-CGS
Advocate
Advocate

Okay if you edit the setup you'll see that chuck reference is at 4.5 in front of stock back. On the operation labeled ROUGH OD SIDE 1 the back references the chuck front and the offset shows invalid reference.

0 Likes

akash.kamoolkar
Autodesk
Autodesk

@PatrickPowers-CGS I've managed to replicate this issue and i'll make a ticket for it.

 

Regards,

Akash Kamoolkar



Akash Kamoolkar
Software Development Manager
2 Likes