Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

using 2d contour for miter fold cuts

mwoodzork
Participant

using 2d contour for miter fold cuts

mwoodzork
Participant
Participant

Hi,

 

I am setting up miterfolds with a 90 degree V groove bit. I'm trying to find the right tool type  In the Fusion library the counter sink bit is the only thing that is close. It seems to work as long as I do not use multi pass. When I try multipass it fails to generate a tool pass every time. No explanation why.

 

Does anyone know why there is this limitation for the counter sink tool and what alternative might work for miterfolds?

 

Thanks

 

 

0 Likes
Reply
781 Views
5 Replies
Replies (5)

LibertyMachine
Mentor
Mentor

Have you tried using a Chamfer Mill?

Capture.JPG

 


Seth Madore
Owner, Liberty Machine, Inc.
Good. Fast. Cheap. Pick two.
0 Likes

mwoodzork
Participant
Participant

No but i will give it a try

 

thanks

 

0 Likes

mwoodzork
Participant
Participant

does not allow multiple passes. 

 

hmmm. it may seem odd but its a large area to cut and from what I have been told by others making muliple passes is advisable. I am still curious why Fusion would prevent multiple passes from being an option with the chamfer mill or counter sink bit. Or why there is no V groove bit?

0 Likes

HughesTooling
Consultant
Consultant

If you're using 2d contour with Compensation set to off you need a tapered mill.

Clipboard01.png

 

For mutiple depths set the taper angle to zero, it will give a warning just click yes and ignore.

Clipboard02.png

 

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature


0 Likes

OliverDownie
Enthusiast
Enthusiast

Here's what I use, with a trace tool path, unless anyone has a better way...

0 Likes