Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Turning ID groove retracting to much and rubbing backside of tool on bore.

josh.sapp
Advocate

Turning ID groove retracting to much and rubbing backside of tool on bore.

josh.sapp
Advocate
Advocate

I'm having an issue of the tool retracting to far, beyond stated retract and clearance, in the bore and rubbing the back side. It is probably something simple but I'm missing it. Could you please have a look at the attached file and give suggestions or see if you can recreate the problem. Thank you in advance.

0 Likes
Reply
Accepted solutions (1)
205 Views
3 Replies
Replies (3)

seth.madore
Community Manager
Community Manager
Accepted solution

Okay, good news and bad news...

Good news is, you're not missing something simple, this is a bug that's been around for a while. 

Bad news?

Well, it's going to be fixed in updated Grooving strategies, which aren't going to be available for our users for some time....


Seth Madore
Customer Advocacy Manager - Manufacturing
0 Likes

Spencer.AC
Enthusiast
Enthusiast

What is the eta on fixing this? I was just about to post about an identical issue.

0 Likes

seth.madore
Community Manager
Community Manager

The new Grooving strategies are a fair bit of time out, I regret to say..


Seth Madore
Customer Advocacy Manager - Manufacturing
0 Likes