Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Turning Heights - From Selection now working correctly

Lonnie.Cady
Advisor

Turning Heights - From Selection now working correctly

Lonnie.Cady
Advisor
Advisor

When using from selection for the inner height there seems to be some issues.  As you can see in the attached image I have from selection and the inner radius indicator is not showing correctly.Autodesk_Fusion_360.png

0 Likes
Reply
421 Views
6 Replies
Replies (6)

HughesTooling
Consultant
Consultant

Have you selected the model on the setup, just came up in another thread and I though you might have the same problem

 

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature


0 Likes

Lonnie.Cady
Advisor
Advisor

@HughesTooling,

Thanks I just double checked and there body is selected in the setup.  So not sure what is up with it.

0 Likes

HughesTooling
Consultant
Consultant

Can you attach the file it's a bit difficult to see quite what the part looks like in the picture.

 

Mark.

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature


0 Likes

HughesTooling
Consultant
Consultant

It looks like some of the options for ID don't work. If you have a hole through the part and select Model ID it picks that up ok.

Clipboard04.png

 

But using selection just picks up the model ID and ignores the selection.

 

Clipboard05.png

 

Mark

Mark Hughes
Owner, Hughes Tooling
Did you find this post helpful? Feel free to Like this post.
Did your question get successfully answered? Then click on the ACCEPT SOLUTION button.

EESignature


0 Likes

Lonnie.Cady
Advisor
Advisor

Also grabbing the manipulator and dragging when in from selection mode does not work correclty.  When I drag up it get goes down and dragging down goes up.

0 Likes

Lonnie.Cady
Advisor
Advisor

From selection actually does not work for the OD either.

 

from selection.png

0 Likes