Announcements
Attention for Customers without Multi-Factor Authentication or Single Sign-On - OTP Verification rolls out April 2025. Read all about it here.

Turning - finishing toolpath doesn't turn over flats in design

AlanMueller
Contributor

Turning - finishing toolpath doesn't turn over flats in design

AlanMueller
Contributor
Contributor

When creating a finishing tool path, Fusion is stopping the turning at the end of the conical taper on my part, rather than continuing straight to the back of the part. Any ideas on how to correct this issue?

AlanMueller_0-1707772443220.png

 

End of tool path has a radius, which appears to begin going along the straight section of the part, but ends there. When "Make sharp corners" is on, the radius disappears, as I would expect.

AlanMueller_1-1707772489033.png

 

 

0 Likes
Reply
Accepted solutions (1)
161 Views
2 Replies
Replies (2)

AlanMueller
Contributor
Contributor
Accepted solution

Simple fix: The issue wasn't spun profile, I had my outer diameter set to the OD of the part, which was where the toolpath was stopping. Adding an offset to my outer diameter field fixed the issue.

AlanMueller_0-1707773126783.png

AlanMueller_1-1707773143435.png

 

 

1 Like

seth.madore
Community Manager
Community Manager

Glad you got it sorted out!


Seth Madore
Customer Advocacy Manager - Manufacturing
0 Likes