- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report
Hello everyone!
I am new in turning CAM but already familiar with Fusions milling CAM.
Some days ago I bought a small nice inclined bed lathe with RÖHM hydraulic chuck SAUTER tool turret and Sinumeric 802s control. I am trying to get the setup done but always kind of fail. I tried several scenarios and as below in the pictures this are the ones closest to the right setup. But still as you can see either the tool is switched down and starts from the right side or is positioned right but starts from the wrong side. I tried everything but could not find a solution.
A setup with standard inclined bed lathe should not be ss. revolutionary or am I wrong?
I welcome any help!!
Thanks!
Bernd
Solved! Go to Solution.
Fusion