Trying to do a mill turn job on the Tormach, never done this with Fusion,.

[kmcgheeCMFPG]

Super easy request, I want to turn some knobs on my Tormach, using mill turn, 1" diameter knobs mounted on a mandrel in the spindle, triangle insert tool clamped in the vice. Not sure how to tool it thou, please have a look at the attached file please?

[kmcgheeCMFPG]

Been able to play with this some more and have gotten this far, but I still and not getting the bottom of the model machined right, anyone out there know how to get this to mill turn?

[daniel_lyall]

Is your post possessor set up for it, there is this dude doing not useing fusion thoe         https://www.youtube.com/channel/UCV3_rIV06tH3iePghJWcKwg

there is a couple here 

https://www.youtube.com/watch?v=qQOpOq1Ce8o

[kmcgheeCMFPG]

I've seen them. The issue is its not post processor, its getting it to simulate correct, and I still end up with an incomplete profile.

[daniel_lyall]

Simulation in fusion or Linux.

The sim in fusion is just a guide does the G code look ok in pathpilot