Tool Path Simulator Jerky and Slow

[ifloyd9]

Has anybody else noticed since the update yesterday the tool path simulator is jerky and slow and also flickering?

[a.laasW8M6T]

No its been working fine for me

I would check the accuracy slider isn't turned up too high

it should be in the position shown here:

[ifloyd9]

Mine is up one notch from yours but usually it would run fine except for complex stuff and then I would lower it. 

Thanks I will just lower it for now and maybe do a GPU driver update or soothing. 

[seth.madore]

It's likely not a GPU setting. 

Are you waiting until all your toolpath In-Process Stocks are calculated? When the checkmark is no longer surrounded by a dashed circle, you'll know it's ready: